Palmer MI

A pedalboard can be a noisy place, and choosing the right power supply can make a big difference to the noise level and clarity of your guitar tone. And that's where the PWT 06 IEC comes in. With six high current, individually isolated, ultra low noise outputs - each with its own dedicated regulator and custom isolated transformer - the PWT... Detaljnije...

No unwanted noise, plenty of output for power-hungry pedals, and slim designThe PWT 08 MK2 power supply stands out with its slim design, which easily fits under almost any pedal boards. The total capacity of 2,000 mA is distributed over eight individually isolated 9V DC outputs.Two of the outputs are adjustable between 6 and 18 volts to simulate... Detaljnije...

The PDI09 can be connected between an effect device or amplifier and the mixing console. The PDI09 is not suitable for direct connection to a guitar. Integrated filter circuits simulate the authentic "speaker" sound. Tone can be varied between "Mellow", "Normal", or "Bright". Detaljnije...

Universal aluminium Pedalboard for the storage of all commercially available floor effects. The cross bars as well as the height and the tilt of the Pedalboard can be individually adjusted. The cross bars are already covered with Velcro (fleece), a sufficient amount of hook strap is also included. Power supplies and similar peripheral devices... Detaljnije...

A Reamping-Box is mainly used in studios. It allows you to play back a recorded guitar signal and send it to a guitar amp, where it can again be taken and recorded by the microphone. This allows the sound engineer to take time to experiment with the sound of the instrument using different amplifiers. The DACCAPO box ensures optimal impedance... Detaljnije...

The concept behind the cab merger may be very simple, but it fills an important gap! Have you ever wanted to connect two guitar cabinets to one amplifier output? The PCABM makes it possible. In addition, you can select whether the cabinets should be wired in parallel or series  with one another. For example, if you interconnect two... Detaljnije...

With the PWC6 you can power up to 6 units from one single power outlet. Considering that most common effects have a power consumption of approx. 20mA, a 300mA power supply such as the Palmer PW9V can thus often suffice to power 6 units. Detaljnije...

Power supply for all Palmer devices with a 9 V input connector and a maximum power consumption of 500 mA. Input Voltage: 100 - 240 V AC 50 Hz Output Voltage: 9 V DC, 500 mA regulated Polarity negative inside Detaljnije...

Universal aluminium Pedalboard for the storage of all commercially available floor effects. The cross bars are already covered with Velcro (fleece), a sufficient amount of hook strap is also included. Power supplies and similar peripheral devices can be mounted below the board. For this the Pedalboard features 4 practical hooks on the underside.... Detaljnije...

Universal aluminium Pedalboard for the storage of all commercially available floor effects. The cross bars as well as the height and the tilt of the Pedalboard can be individually adjusted. The cross bars are already covered with Velcro (fleece), a sufficient amount of hook strap is also included. Power supplies and similar peripheral devices... Detaljnije...

With a stable 250 mA on each of the five center negative barrel style outlets the compact Palmer PWT 05 MK2 is most suited to virtually any pedalboard size. To deliver clean DC power to your pedals and eliminate ground loops between them and the associated hum the outlets are isolated.The PWT 05 MK2 is protected against overload and comes... Detaljnije...