Pretraživanje artikala
Napredna pretraga

Naziv proizvoda

Behringer EPX4000

Behringer EPX4000
[klikni na sliku za uvećan prikaz]
  • Behringer EPX4000
  • Behringer EPX4000
Naša cena:
55.800,00 DIN

Detaljnije o cenama

Garantovano najniže cene

Ukoliko pronađete povoljniju ponudu za ovaj instrument, dobićete ga od nas jeftinije za 10% od razlike u ceni!

Opis proizvoda:

Power amps have always been heavy, mainly because of their massive transformers and heat sinks. Our new EPX Series amps are based on groundbreaking switch-mode power supply technology, which eliminates the heavy transformer. As a result, these amps weigh about 40% less than their conventional counterparts. In fact, the EPX4000 is just 22.3 lb. (10.1 kg), so you can practically lift it with just one finger. Best of all, EPX Series amps are super-reliable and provide even tighter bass performance than their predecessors, since they can deliver ultra-high peak currents on demand.

In a Class of Their Own

The secret to the EPX Series’ incredible power-to-weight ratio is the use of a switch-mode power supply combined with Class-H topology. Because they work on demand, instead of operating continuously at full power, switch-mode power supplies are much more efficient than traditional power supplies. And since they don’t require the massive transformers and heat sinks typically found in conventional power amps, they are significantly smaller and lighter, yet still deliver ample power.

Think of a Class-H amp as being similar to a car with two engines (in amps, they are called “rails”). One engine runs all the time. The other runs only when musical peaks demand the extra power output. An EPX Class-H amp only generates a fraction more power than is immediately needed, while the output stage operates at its maximum efficiency all the time. And just like in today’s hybrid cars, the efficiency of this dual system is far greater than having just one engine or rail that has to operate continuously.

Accelerated Transient Response Delivers the Knockout Punch

It takes huge pulses of energy (current and voltage) to propel a woofer cone out fast enough to match a bass beat. That’s called Transient Response and it’s the holy grail of amp designers. By carefully selecting transistors with extremely high slew rates and optimizing other proprietary parts of Behringer’s circuitry, EPX amps can react instantly to even the most demanding electronic bass impulses. If the woofers in your PA system can keep up, your audience will hear a tighter, crisper, more natural sound.

BEHRINGER didn’t invent Class-H technology, but Behringer’s R&D Department has been working for years to perfect their own version, creating lightweight amps that run cool and achieve our goal of Accelerated Transient Response.

Everything You Need

The simple front panel controls of these amps give you all of your sound’s vital signs at a glance. After pressing the Power Button, the POWER LED will light when the amp is ready for action. Both channels have independent gain dials, as well as CLIP LEDs that notify you when the signal is distorted and you need to reduce the gain. There are also SIGNAL LEDs that light up when a signal is present at the input.

Panel Discussion

The EPX Series’ INPUTs accept balanced XLR, ¼ " TRS, and unbalanced ¼ " TS and RCA connections. Take your pick of professional locking speaker outputs or touch-proof binding posts to securely connect speakers.

A panel of switches located on the back off ers an array of cool options applicable to both channels. The switchable Clip Limiter lets you get even more out of the amplifier without overdriving either it or your speaker system. Built-in circuitry automatically senses when the amp is being overdriven into “clipping” and instantaneously reduces the input level just enough to avoid clipping distortion.

Built-In Crossover

The rear panel also contains a switch that allows you to put these amps to work in mono, stereo (two-channel mode) or bridge mode, which is always mono. A built-in CROSSOVER switch lets you put the amp into biamp mode, which sends low-frequency content (< 100 Hz) to the CH2 Output and the high-frequency component to CH1 automatically, no external hardware required.


BEHRINGER’s EPX Series amps are built for the working musician. They are much lighter than conventional power amps, pack massive power, feature built-in crossover and limiter circuits, and can withstand the rigors of the road. Plus their light price tag will leave money in your pocket to buy more stuff to amplify!


Output Power

-RMS Power

Stereo Mode (both channels driven)

8 Ω per channel, stereo 530 W

4 Ω per channel, stereo 870 W

2 Ω per channel, stereo 1440 W

Bridged Mono

8 Ω / 1 kHz @ 0.1% THD 1800 W

4 Ω / 1 kHz @ 1% THD 3000 W

-Peak Power

Stereo Mode (both channels driven)

8 Ω per channel, stereo 670 W

4 Ω per channel, stereo 1220 W

2 Ω per channel, stereo 2080 W

Bridged Mono

8 Ω bridge mode 2450 W

4 Ω bridge mode 4000 W

Input Sensitivity 1 V

Distortion <0.01%

Frequency Response 20 Hz - 20 kHz, +0/-1 dB

Voltage Gain 35 dB

Damping Factor > 300 @ 8 Ω

Input impedance 10 kΩ unbalanced, 20 kΩ balanced

Signal-to-Noise > 100 dBA


Front POWER switch GAIN control (channel 1 and 2)

Rear MODE switch X-over Switch, BRIDGE MODE switch



CLIP (per channel): Blue LEDs

PROT (per channel): Blue LEDs

SIGNAL (per channel): White LEDs -20dB~-10dB

SIGNAL (per channel): White LEDs -10dB~ 0dB


Inputs: Balanced XLR, 1/4" TRS , RCA

Outputs: Speakon and “touch-proof’’ binding posts


Inputs: Balanced XLR, 1/4" TRS , RCA

Outputs: Speakon and “touch-proof’’ binding posts

Circuit protection: Cooling Continuously variable speed fan, back to front airflow

Amplifier protection Full short circuit, open circuit, thermal,

ultrasonic, RF protection. Stable into reactive or mismatched loads

Output circuit type: Class H

Power supply / Voltage (Fuses)

USA / Canada: 120 V~, 60 Hz (T 30 A H 250 V)

UK / Australia: 240 V~, 50 Hz (T 15A H 250 V)

Europe: 230 V~, 50 Hz (T 15 A H 250 V)

Japan: 100 V~, 50-60 Hz (T 30 A H 250 V)

Power consumption: 4500W

Mains connector: Standard IEC receptacle

Dimensions (H x W x D) 3.46 x 19.01 x 14.68"

88 x 483 x 373 mm

Weight 22.26 lb. / 10.10 kg

Popularni proizvodi:
Behringer EP4000 EUROPOWER Behringer EP4000 EUROPOWER
Cena: 64.073,00 DIN  
Crown XLS1000 * Crown XLS1000 *
Cena: 63.004,00 DIN  
Yamaha P3500S * Yamaha P3500S *
Cena: 67.574,00 DIN  
Behringer EPQ2000 Behringer EPQ2000
Cena: 59.243,00 DIN  
Behringer EP2000 EUROPOWER Behringer EP2000 EUROPOWER
Cena: 48.308,00 DIN  
Crown XLS2000 * Crown XLS2000 *
Cena: 101.630,00 DIN  


Admirala Geprata 10
+381 11 664 99 99
+381 11 7617 668; 10h - 20h

Novi Sad

Sutjeska 2, SPC SPENS
+381 21 450 800; 10h - 20h


Obrenovićeva BB, TC Kalča
+381 18 250 670; 10h - 18h


Milutina Milankovica 23, Novi Beograd
+381 11 3011 950; 09h - 17h